Recommendation

Start Accelerate opens Acknowledge the disclaimer. You can close it. Staff cannot accept it for you.

The notice says the configuration information is a simulation from current network data, for information only. Optimum does not guarantee a performance outcome. Changes you make on your own infrastructure are your decision, and Optimum is not liable for the outcomes of using that information.

Read the text in the dialog. The copy on this page is a summary so you know what the step is. The dialog is the agreement.

After you accept, Bid cutoff asks you to upload the MEV-Boost configuration you actually run. Console compares it with what your proposals show. It still does not change anything on your side.

If the configuration is already on file and the terms are not yet acknowledged, the screen says One thing before your recommendation. Read and acknowledge opens the same dialog. The recommendation stays hidden until you accept.

If you have no file yet, Download a starter file. The download is mev-boost-config.yaml, with the known mainnet relays and MEV-Boost’s default cutoff. It is a starting point, not a config Console has applied.

Until a file is on record, the report has no cutoff to judge proposals by. The screen says No configuration uploaded yet.

The recommendation itself is withheld below 200 measured proposals. The callout is Not enough proposals yet for a recommendation. See Readiness.

Once the window can support a number, the panel is Recommended bid cutoff, in milliseconds, with I am ready to adjust. The line under the number is the move from your current cutoff, and how much time that leaves before local block building. Replace the config on file uploads a different file.

Beside it:

• Slots that could have improved — the share of MEV blocks that had a better bid within a stated offset past the bid you took, over the modelling window.
• Slots modelled — MEV blocks in that window.
• Relays on file — how many relays the uploaded config names. Upload your own file if you want this to be your set.

The figure is uplift that was available at that offset, on blocks already proposed. It does not price the risk of waiting. No cutoff change indicated means the window does not support moving it.

When a cycle completes, the top of the screen says Your measurement cycle is complete and how many proposals were measured since your last change. Review the recommendation opens this step. Dismissing hides the notice until the next cycle. Accelerate in the sidebar shows 1 until you answer.