Appearance

What Accelerate does ​

Accelerate recommends a MEV-Boost bid cutoff from slots your validators already proposed. Console never writes to your infrastructure. You upload the MEV-Boost configuration you run, read a recommendation, and download a config to deploy yourself. Nothing on this screen changes validator behaviour until you deploy that file.

Who can use it ​

Accelerate is for entity accounts. An individual account has Signal only. See Account type.

A recommendation needs 200 measured proposals (Readiness). An individual operator rarely proposes that many in a window short enough to act on, so the flow is offered to entities.

If you registered as an entity and Accelerate is not in the sidebar, it is not enabled for your account yet. Ask support. There is no other URL to use.

The steps ​

  1. Start Accelerate — prerequisites, including the disclaimer.
  2. Recommendation — your config, and the recommended bid cutoff once the window can support one.
  3. Adjust — you record the cutoff you will deploy, then download the config on file.

Where you land on a return visit follows what is already stored. No acceptance sends you to step 1. Acceptance without a saved config sends you to the recommendation. A saved config sends you to adjust. If the terms change, the previous acceptance no longer counts and you start again.

When a measurement cycle finishes and you have not answered it, Accelerate in the sidebar shows 1, and the screen leads with Your measurement cycle is complete. Review the recommendation opens step 2. Dismissing hides that notice until the next cycle completes.

What it measures ​

Every figure is measured on slots you already proposed. Console does not forecast an annual gain. The figures sit on this screen, under MEV outcome. See Where results show.

Older names on some screens ​

The sidebar entry and the screen heading are Accelerate. Results are MEV outcome on that screen. There is no MumBoost item under Performance, and the title MEV Cutoff Optimisation is not on this screen.

A direct link to the older report can still show two MumBoost messages: Could not check the MumBoost terms, and This operator has not accepted the MumBoost terms. Both mean the same check on Accelerate. See Where results show.